- cross-posted to:
- beginner_woodworking@lemmy.ml
- woodworking@lemmy.ca
- cross-posted to:
- beginner_woodworking@lemmy.ml
- woodworking@lemmy.ca
cross-posted from: https://mander.xyz/post/12406051
I’m not sure where the right place to post this would be, but here goes.
I bought this DW745 Type 2 saw off of Facebook Marketplace. I think it was abused. I replaced both of the elevating shafts (5140100-04 & 5140100-05). I also had to replace both of the bevel gears (5140061-65).
The aluminum housing seems to be okay and the lifting shafts move in and out without much resistance. I’m still getting this chunky movement when I raise and lower the blade.
I’m looking for advice before I go though the whole process of replacing the entire aluminum housing on the motor.
You must log in or register to comment.