Hello. I’m a hobbist on electronics repairs, and I did some repairs on stuff powered from the wall socket before, using a serial bulb to protect the circuit in case there’s a short. Now I want to troubleshoot a board that works at 3V and very low current (like no more than 100mA). So, how can I properly size the bulb I need for this circuit before powering it? Or is there a better way to protect the circuit than a serial bulb? Thanks in advance.

  • jjagaimo@lemmy.one
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    Ah. It’s not going to be possible to size it because the bulb is then acting as a resistor essentially. Unless you know what the equivalent resistance of the circuit you’re testing is, and it draws a fixed current, you aren’t going to be able to cap the current; Adding a resistor (or bulb) is just going to drop the input voltage and you will probably end up having other issues

    • LemmyBr785OP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Ah got it. Then a bench power supply is the way to go. Thanks again!

    • rstein
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      And the bulb is a strange resistor, it has a really high current when starting up cold. This can fry everything behind it.

      • ConductiveInsulation@feddit.de
        link
        fedilink
        English
        arrow-up
        3
        ·
        1 year ago

        It has the high current because it’s cold, it only needs a short time to heat up and light up and the majority of circuits can handle very short overcurrent really well because the connections need to heat up before they break. Using a lightbulb for current limiting works pretty well.