I just came across this and thought I’d share. I’ve struggled to get headers and IC’s off boards after soldering them on backwards/upside down. This video shows a cool trick with a piece of copper wire that makes them very easy and quick to get off without expensive tooling. I was thoroughly impressed. Hope someone else finds this useful too.

  • lxpw@lemmy.ca
    link
    fedilink
    English
    arrow-up
    3
    ·
    1 year ago

    I picked up a Hakko desoldering gun many years ago to save me from this. It was pricey (~$300), but has been worth it over the years.

    • naonintendois@programming.devOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      This trick might be more useful for people who are budget constrained. In the past I’ve resorted to cutting the plastic between the headers (making them unusable), so this is a nice alternative without the need for another tool. If budget wasn’t an issue I’d likely buy a much nicer iron and an extra wide knife-style tip.

      • Saigonauticon@voltage.vn
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Haha, I’ve done that too. However sometimes it rips the pads off or otherwise damages the vias. So instead I cut them along the other axis (parallel to the PCB), then remove the remaining nibs.

        These days I mostly use a hot air rework station though. In my city this is integrated with many soldering stations on the market, for maybe an extra 10$. I think mine is Yihua brand, it’s quite OK.

    • deksesuma@beehaw.org
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Same. It’s been a lifesaver and a confidence booster because I know I can more easily recover from mistakes.

  • skillissuer
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    this only works well if you have good soldermask in place

  • Sir_Kevin@discuss.online
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    I was ready to shit on this but I could definetely see some uses when there are a lot of through hole pins. I’d be a little worried about keeping the heat distribution even though.

    • naonintendois@programming.devOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      I thought it might be useful to move the iron back and forth a little for long rows. Wouldn’t be perfectly even but would be better than concentrating heat in the center.

      • Rolivers
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Well the copper should disperse the heat fairly quickly. It should be okay.