The UI of Prusa slicer is hot garbage though. I started with prusa slicer and moved to orca after a few months. Orca is a much nicer experience, and the built-in test-models (temp towers etc.) are nice.
In find the location and grouping of parameters more intuitive in orca. I always had to look through several tabs to find the parameter I wanted to adjust when I was using prusa, it was never where I thought it should be.
The UI of Prusa slicer is hot garbage though. I started with prusa slicer and moved to orca after a few months. Orca is a much nicer experience, and the built-in test-models (temp towers etc.) are nice.
I’m comparing cura and prusa, so prusa wins by a lot. What are you comparing prusa to? Orca?
Yes
I give orca/bambu the edge for “prettier on screenshots”, but in practice, I don’t find their UI paradigm to be more efficient nor convenient.
In find the location and grouping of parameters more intuitive in orca. I always had to look through several tabs to find the parameter I wanted to adjust when I was using prusa, it was never where I thought it should be.