Edit: Thanks to everyone for the help! Just an update.

Thanks to @nate3d and @IMALlama comments below I calibrated the e-steps that were very under and it improved a lot.

I left the filament on the dryer for 8 hours and tested again with a 20mm /s speed and 220 C print temp and it was better (picture below)

Just to answer you all saying it’s a clog or a hot end problem, it’s not, the whole hot end, includong nozzle, heat block and everything else, even the PTFE tube are all brand new and I checked before.

This is still the best I could achieve and It took 3 hours to print this benchy lol

‐-------- Hi everyone, I’m once again asking for your help lol Since I’ve tried to print with wood I totally wrecked my printer so I changed the hot end and am trying to set it all up again. Since my printer already came built and working I don’t have much experience with things like this so if you could help me I would be very thankful

What do I need to twerk to make it print better again?

I’m using Cura slicer and trying to print a benchy with the settings below:

Nozzle: 0.4

Layer: 0.2

Printing temp: 220 (it wont print with lower temp)

Speed: 60

Retraction distance: 7

Retraction speed: 70

Edit: PLA

    • Fubarberry@sopuli.xyzEnglish
      2·
      3 months ago

      It really sounds like you have a major problem with the printer that needs to be resolved. Without knowing any more details I would suggest making sure the nozzle isn’t clogged and possibly replacing the hot end.

      • MissJinx@lemmy.worldOPEnglish
        2·
        3 months ago

        It’s a new hot end and new nozzle, that’s why I pretty sure it can’t be a clog or hotend problem. It was having this issues before and I changed the whole hotend for a brand new

        • Fubarberry@sopuli.xyzEnglish
          1·
          3 months ago

          Huh, possibly bad extruder? If it’s got weak extrusion it might only be able to push it through the nozzle at higher temps.

          • MissJinx@lemmy.worldOPEnglish
            1·
            3 months ago

            I posted an update. It’s very clear my printer has a problem I just can’t figure it out. I will try to change the extruder but It seems to be working fine… anyway, I’ll keep trying

    • ShepherdPie@midwest.socialEnglish
      1·
      3 months ago

      What kind of printer is it? Do you maybe have a direct drive extruder while using Bowden style retraction settings?