IMG_20231111_205431

I cant get my Anycubic Kobra 2 with Klipper to print correct. The first mm of each layer are faulty, resulting in a bad tooth in gears.

I tried to slow down the print, tried to minimize/deactivate retraction, fiddled with z offset and first layer height, lowered bed temp, altered the extrusion rate. Nothing works. Everything else seems fine, slim z seam, nice walls, no over/underextrusion.

Anyone got a hint how i could fix that?

Edit: I cancelled that Print, the Problem is only in the first tooth:

IMG_20231111_212736_745

the tooth in the marking should look like the ones above it.

    • PixeIOrange@feddit.deOPEnglish
      1·
      8 months ago

      In PrusaSlicer externals first, in cura outside to inside. Whats weird in cura, it prints the outter wall ls first half gears first, then the spokes from the second half.