https://www.youtube.com/watch?v=x79l7UO_qww

Caveat: The bike used is an e-bike with a powered wheel. The pedals have very little load requirements and no long-term or load testing is shown. As one of the most hardcore roadies you’ll ever interact with, personally, I believe this would not last more than a week if it could survive a single ride on a traditional bike and someone like myself based on my first impression of the design. Still, the idea is impressive to me. In practice, a robust enough design will likely outweigh a chain drive by an order of magnitude. The reason the chain and cog transmission is standard is because of the balance of weight to durability. Every single gram matters on a bicycle far more than may be apparent at first.

  • SzethFriendOfNimi@lemmy.world
    link
    fedilink
    English
    arrow-up
    7
    ·
    2 days ago

    Sounds like the perfect thing to test and iterate and then use that to have something machined in metal.

    Of course with some stronger materials it may be fine. But how resilient will the belts be from the tension/stress and is there any risk of injury when they snap?

    • j4k3@lemmy.worldOPM
      link
      fedilink
      English
      arrow-up
      8
      ·
      1 day ago

      These are basically timing belts for cars. Inside the belt are usually metal or aramid fibers that prevent any elongation of the tooth pitch. A lot of the automotive aftermarket principals of a timing chain versus a timing belt drive apply exactly the same here. The belt lasts longer and operates dry with more accuracy over time.

    • unexposedhazard
      link
      fedilink
      English
      arrow-up
      4
      ·
      1 day ago

      Belts are a standard system for bikes already. Its the printed parts that are scary.