Not looking for support, just wanted to show newcomers that good printers with good calibration also can make spaghetti.
I’m not entirely sure what happened here, as I didn’t pay attention, but stuff like this usually happens when a booger of nozzlesnot sticks to the print somewhere and hardens, and next time the unsuspecting print head comes along it hits the (now solidified) snot, and the belts skip a tooth or two.
The squid are nice, but you need a hotend blob if you want to get higher than 6 out of 10. A blob that also consumed a silicon sock will get you to 9, probably.
You’re not truly alive until you’re cooking your extruder assembly with a heat gun to get enough solidified plastic off of it just to take it apart.
What about a partially cleaned blob… of PP… that also went inside the sock?