All blades have the same size, 36cm long, aerodynamically well shaped. But. The first weighs 120g, the second 125g… And the third one 210g… This is a small problem. So what are my options now? Making a new blade would be the last option, but do I have any other options?

  • Uresname@lemmy.dbzer0.com
    link
    fedilink
    arrow-up
    8
    ·
    1 year ago

    I have no experience here but could you add weight to the others to make them heavier? Maybe tape strips that will have minimal aerodynamic impact? If not, maybe sand or shave down the heavier ones until they match?

  • 7eter@feddit.de
    link
    fedilink
    arrow-up
    7
    ·
    1 year ago

    I don’t believe that the reason for this is density changes of the wood but more likely imprecise dimensions. I can’t really tell from the picture, but the lower blade seems slightly larger or maybe even thicker.
    For example, the section marked in green at the heavy blade seems to be bigger than the blue marked section of the light blade. So I would suggest sand paper.

  • Bob Robertson IX
    link
    fedilink
    arrow-up
    7
    ·
    1 year ago

    Drill a hole in the heaviest one then use putty to cover the hole back up. For the one that’s just slightly heavier you could probably remove enough with sandpaper to even them out.

  • YeetPics@mander.xyz
    link
    fedilink
    arrow-up
    4
    ·
    edit-2
    1 year ago

    Could recess on the underside of the lighter fins near the center of mass and add some weights to balance. I’m picturing those rim-weights they use for car tire balancing. Organic materials usually have these weird density variations.

    You could rebuild with a more density-consistent wood, I’m picturing really light like balsa or really dense like red oak or something. Assuming these are from stock 2x lumber you should check the butt ends and try to match the ring thickness and minimize the knots in your lumber pick.

    Idk about sanding/removing off 80g worth of material without affecting aerodynamics.

    Can I ask your process for making these?

    • Peter Arbeitslos@feddit.deOP
      link
      fedilink
      Deutsch
      arrow-up
      3
      ·
      1 year ago

      First: Thanks dir the information and ideas, maybe I’ll try it in this way (still collecting ideas). Second: It’s my first wheel, I cut the rough shapes out of a board and shaped it by filing, cutting and sanding.

      • YeetPics@mander.xyz
        link
        fedilink
        arrow-up
        2
        ·
        edit-2
        1 year ago

        Happy to help, although I have no clue what you’re building.

        Is this for a wind turbine?

  • thisNotMyName@lemmy.world
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    Take some sand paper and grind a little off of the heavier ones? (No idea if that would ruin your aerodynamics too much)